Another driver might crowd your lane or change lanes without looking and crash into you. Avoid driving directly alongside other vehicles on multilane streets with or without traffic in the opposite direction.The other driver may not see your vehicle and could change lanes and hit you. Do not stay in another driver’s blind spot.To maintain enough space on each side of your vehicle: Before you enter an intersection, look left, right, and ahead for approaching traffic ![]() ![]() #Drive ahead pc online driver#Drive ahead pc online driversSome drivers do not obey traffic signal lights. Take one more look to the left in case there is a pedestrian, bicyclist, or vehicle you did not see the first time.Look to the left first, since vehicles coming from the left are closer to you than vehicles coming from the right.Look both ways even if other traffic has a red traffic signal light or a stop sign.Always look to each side of your vehicle at intersections, crosswalks, and railroad crossings. These vehicles must stop at railroad crossings.Īny time you come to a place where people may cross or enter your path or a line of traffic meets another, you should look to the left and right sides of your vehicle to make sure no one is coming. You see a bus, school bus, or a placarded vehicle at railroad crossings.The extra space allows you to see around the vehicle. Following large vehicles that block your view ahead.The extra weight makes it harder to stop. Towing a trailer or carrying a heavy load.Allow room in front of your vehicle so the driver will have space to move in front of you. Motorcyclists and bicyclists can fall easily on these surfaces. Following motorcyclists or bicyclists on wet or icy roads, metal surfaces (e.g., bridge gratings, railroad tracks, etc.), and gravel.Slow down gradually or merge into another lane to prevent a collision with the tailgater! Allow extra space ahead and do not brake suddenly. If you pass the same point before you finish counting, you are following too closely. To avoid tailgating, use the “3 second rule”: when the vehicle ahead of you passes a certain point, such as a sign, count “one-thousand-one, one-thousand- two, one-thousand-three.” This takes approximately 3 seconds. This gives space between you and the vehicle ahead, without having to slam on your brakes or swerve into another lane. If a vehicle merges in front of you too closely, take your foot off the accelerator. Many drivers follow too closely (tailgate) and are not able to see as far ahead as they should because the vehicle ahead blocks their view. Know which lanes are clear so you can use them, if necessary. Be prepared for rapid changes in road conditions and traffic flow. Expect merging vehicles at on-ramps and interchanges. On the freeway, be ready for changes in traffic conditions. Do not develop a “fixed stare.” Check your rearview mirrors so you know the position of vehicles near you. Watch for hazards–Look beyond the vehicle ahead of you.
0 Comments
Leave a Reply. |
AuthorJames ArchivesCategories |